This page was printed from https://fabricarchitecturemag.com

Approximate allowable max. tensile load in threaded fasteners loaded in tension and shear

By: / Uncategorized

This table shows the approximate allowable max. tensile load in threaded fasteners loaded in tension and shear.

Notes:

  1. Above allowable tensile loads are based on Ft=26-1.8fv≤20, where Ft is the allowable tensile stress, fv is the actual shear stress.
  2. Fu, the ultimate strength of the fastener, is assumed to be 40 k.s.i.
  3. The fastener is assumed to be loaded in shear to 0.1875 Fu=7.5 k.s.i.

Leave a Reply

Your email address will not be published. Required fields are marked *

Comments are moderated and will show up after being approved.