This page was printed from

Polyfab USA 2013 Tension Shade Workshop schedule and appearances

News | February 18, 2013 | By:

Polyfab USA’s 2013 Tension Shade Workshops are set for this spring, starting Feb. 22 at Trivantage™ in Lithia Spring, Ga.

At each workshop, attendees will break into small groups and visit four different stations with each station covering a different topic.

  • Station one: Site survey and measuring— Traditional and “state of the art” measuring will be discussed.
  • Station two: CAD & Design— A number of computer workstations will be set up with Shade Designer software so attendees can design their own shade sail.
  • Station three: Cutting, sewing & manufacturing techniques— There will be a sewing machine set up for a demonstration and supervision of various techniques.
  • Station four: Installation & tensioning procedures— Attendees will have the chance to install the shade sail on-site.

The workshop schedule is as follows:

Polyfab USA is also planning a smaller hands-on workshop in conjunction with the Western Canvas Products Association Annual Expo:

In addition, Polyfab USA will also be exhibiting at the following seminars:

  • Date: Saturday, March 2
    Place: Trivantage, 16 Worlds Fair Drive, Somerset, NJ 08873
    Register: Your local Trivantage account representative.
  • Date: Friday, March 8
    Place: Hilton Garden Inn, 2190 East Lamar Blvd., Arlington, TX 76006
    Register: Your local Trivantage account representative.

Source: Polyfab USA

Share this Story

Leave a Reply

Your email address will not be published. Required fields are marked *

Comments are moderated and will show up after being approved.